[Elecraft] Remote AC power switch?

[Michael Walker]

I bought a pile of these at $20 US each.

http://www.digital-loggers.com/iot.html

I drive them with PI's or just about anything.  It takes any logic from +3V
to 120Vac to control them.

I found that all the other options are great, but very very expensive for
what they are.

Mike va3mw


On Tue, Sep 13, 2016 at 12:38 PM, iain macdonnell - N6ML <ar at dseven.org>
wrote:

> On Tue, Sep 13, 2016 at 8:04 AM, Jim Miller <jim at jtmiller.com> wrote:
> > For those of you implementing remote operation: what are you using for an
> > IP accessed power switch? I need one port to control station A/C power
> and
> > another to toggle the K3s power control line on the ACC connector.
>
> I use an old ("telnet" interface) WTI Network Power Switch that I
> rescued from a recycle pile. Digital Loggers Inc make a
> good/inexpensive "Web Power Switch".
>
> For powering-on the K3 via ACC pin 8, I use a RS232 port on an onsite
> PC, with the same simple circuit used for FSK keying.
>
> 73,
>
>     ~iain / N6ML
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to va3mw at portcredit.net
>