[Elecraft] KXPA100 - Programming Commands

[Dick Dievendorff]

The most recent KXPA100 Programmer's reference is 1.18.  

No new commands have been recently added.  What was added in 1.35 was the
ability to HOLD the MODE button to toggle PA operate/standby (PA bypass).

The KXPA Utility uses ^OP to change PA bypass. This is described on page 19
of the KXPA Programming Reference.  ^OP is not at all new.

73 de Dick, K6KR

-----Original Message-----
From: Elecraft [mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Neil
Zampella
Sent: Saturday, July 16, 2016 06:31
To: Elecraft at mailman.qth.net
Subject: [Elecraft] KXPA100 - Programming Commands

Hi all,

Having just sprung for a KXPA100 to pair with my KX3, a PX3 and W2 are in my
future, I've been playing around with setting commands up for it 
on DXLab Commander.    I've setup the command to switch antennas, by 
adapting some command sequences created for the K2 & K3 and posted to 
the DXLab Yahoo group.    There are some good resources there for 
Elecraft & DXLab integration.

However, the KXPA100 Programmer's Reference available on the website is 
current to firmware revision 1.18, and the latest is 1.35.   1.35 added 
a function to disable the amplifier, but allow the KX3 to use the 
amplifier's ATU.    This functionality is controlled by the KXPA100 
utility, so there must be a command sequence that will perform this
function.

Has this command sequence been released to the public?

Thanks,

Neil Zampella
KN3ILZ
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html Message
delivered to dick at elecraft.com