[Elecraft] KXPA100 - Programming Commands

[Neil Zampella]

Hi all,

Having just sprung for a KXPA100 to pair with my KX3, a PX3 and W2 are 
in my future, I've been playing around with setting commands up for it 
on DXLab Commander.    I've setup the command to switch antennas, by 
adapting some command sequences created for the K2 & K3 and posted to 
the DXLab Yahoo group.    There are some good resources there for 
Elecraft & DXLab integration.

However, the KXPA100 Programmer's Reference available on the website is 
current to firmware revision 1.18, and the latest is 1.35.   1.35 added 
a function to disable the amplifier, but allow the KX3 to use the 
amplifier's ATU.    This functionality is controlled by the KXPA100 
utility, so there must be a command sequence that will perform this 
function.

Has this command sequence been released to the public?

Thanks,

Neil Zampella
KN3ILZ