[Elecraft] KXPA100 - Programming Commands

[Neil Zampella]

Hi Dick,

OK, I misunderstood this as a new feature, from the Elecraft website 
firmware notes:

  * Add manual switch to disable amplifier with ATU available:
  * MODE button HOLD now toggles power amplifier bypass.
  * Power ON LED blinks slowly when PA is bypassed.

So, based on what you're saying, I can use ~OP0 to bypass the amplifier, 
but still have access the KXPA100's ATU, right?

Great ... thanks for that clarification.

Neil Zampella
KN3ILZ


On 7/16/2016 9:51 AM, Dick Dievendorff wrote:
> The most recent KXPA100 Programmer's reference is 1.18.
>
> No new commands have been recently added.  What was added in 1.35 was the
> ability to HOLD the MODE button to toggle PA operate/standby (PA bypass).
>
> The KXPA Utility uses ^OP to change PA bypass. This is described on page 19
> of the KXPA Programming Reference.  ^OP is not at all new.
>
> 73 de Dick, K6KR
>