[Elecraft] [PX3] - symmetrical reflections about the center point

[Eric Swartz - WA6HHQ, Elecraft]

Hi Kevin,

Try removing each end of the IQ cable between the KX3 and PX3 and firmly 
re-inserting it. What you are seeing usually is the result of one end not being 
fully inserted in the jack, leaving one of the IQ lines open.

Eric
/elecraft.com/

On 1/10/2016 4:42 AM, kevino z wrote:
> Not sure if it was the loading of the new KX3 firmware, or if I changed some settings, but now on my PX3 panadapter, I see everything symmetrically mirrored around the center. So for example, If there is a signal at Center frequency -50kHz, it appears at +50kHz too. As I move the VFO, the signals eventually converge and pass through the middle on their way to the ends of the display.Anyone have any idea how to fix this, or what I did to get in this mess?thank you -Kevin (KK4YEL) 		 	   		
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to eric.swartz at elecraft.com
>