[Elecraft] [PX3] - symmetrical reflections about the center point

[Don Wilhelm]

Kevin,

That is what happens if only one of the I/Q channels is connected. Make 
certain your I/Q cable is fully inserted - check both ends.

73,
Don W3FPR

On 1/10/2016 7:42 AM, kevino z wrote:
> Not sure if it was the loading of the new KX3 firmware, or if I changed some settings, but now on my PX3 panadapter, I see everything symmetrically mirrored around the center. So for example, If there is a signal at Center frequency -50kHz, it appears at +50kHz too.