[Elecraft] K3 unable to change passband control shift amount in SSB

[Grant Youngman]

Did you try resetting the passband to "normal" by doing a long press on the control? 

Sent from my iPhone

> On Feb 23, 2016, at 3:31 PM, Jeff Schmidt <jeff at kc9wsj.us> wrote:
> 
> I can no longer select low cut/high cut (vs. shift/width) in LSB/USB.
> A little homework reveals that this as a known side effect of changing the passband shift from its default.
> I'm sure I must have changed the PB CTRL to .01 at some point, but I can't seem to change it back; a firmware reload didn't help. Moving VFO A while in config:PB CTRL gives "N/A".
> 
> Note that this is only manifesting itself on SSB (all other modes are set to the default of .05, and selecting hi/lo / shift/width works FB).
> 
> S/N 7080, old synths
> versions before/after firmware reload:
> 5.38 1.25 2.86 2.86 1.03
> 
> --
>