[Elecraft] K3 unable to change passband control shift amount in SSB

[Jeff Schmidt]

I can no longer select low cut/high cut (vs. shift/width) in LSB/USB.
A little homework reveals that this as a known side effect of changing 
the passband shift from its default.
I'm sure I must have changed the PB CTRL to .01 at some point, but I 
can't seem to change it back; a firmware reload didn't help. Moving VFO 
A while in config:PB CTRL gives "N/A".

Note that this is only manifesting itself on SSB (all other modes are 
set to the default of .05, and selecting hi/lo / shift/width works FB).

S/N 7080, old synths
versions before/after firmware reload:
5.38 1.25 2.86 2.86 1.03

--
73,
Jeff KC9WSJ
@ EN52wf