[Elecraft] K3 unable to change passband control shift amount in SSB

[Jeff Schmidt]

Thanks, Grant, I'm not sure what you mean.

'shift lo'
short press shows 'FC 8 1.50' (expected when config:PB CTRL is set to .01)
long press works, I can set <--Norm-->, as does long press+left/right 
(NORM1/NORM2)

'hi width'
short press shows 'BW 2.80' (expected when config:PB CTRL is set to .01)
long press switches between 'I' & 'II'

Jeff

On 2/23/2016 15:48, Grant Youngman wrote:
> Did you try resetting the passband to "normal" by doing a long press on the control?
>
> Sent from my iPhone
>
>> On Feb 23, 2016, at 3:31 PM, Jeff Schmidt <jeff at kc9wsj.us> wrote:
>>
>> I can no longer select low cut/high cut (vs. shift/width) in LSB/USB.
>> A little homework reveals that this as a known side effect of changing the passband shift from its default.
>> I'm sure I must have changed the PB CTRL to .01 at some point, but I can't seem to change it back; a firmware reload didn't help. Moving VFO A while in config:PB CTRL gives "N/A".
>>
>> Note that this is only manifesting itself on SSB (all other modes are set to the default of .05, and selecting hi/lo / shift/width works FB).
>>
>> S/N 7080, old synths
>> versions before/after firmware reload:
>> 5.38 1.25 2.86 2.86 1.03
>>
>> --
>>

-- 
73,
Jeff KC9WSJ
@ EN52wf