[Elecraft] T1 as stopped tuning correctly.

[Steve-KI4EZL]

Thanks Don.

In the video I posted on youtube, the blinking yellow is actually the self test sending code for each value.

The green light was blinking when in first step of tune mode, then touch paddle to start 2nd step of tune mode.  Normally it moves around trying different tunings and latches on to the best one.  Now, it just has steady tone, steady green light, flickering yellow a tiny bit, but does not try different tunings and does not latch, and does not finish the tuning, like it use to.   I ran the self test and the blinking yellow light showed the following results.

S=1R0,        SWR
V=8R9,        BATTERY VOLTAGE
L=0,             INDUCTANCE
C=0,             CAPACITANCE
N=t,              NETWORK CONFIG
B=0,              BAND ID
F=1R07          FIRMWARE  REVISION

Tested following with neg dmm lead on neg bat tab.  No battery in device tested. Red DMM lead on parts ends, one at a time:
D1:  122/0
D2:  122/0
R3:   120 / 117
R4:   120  / 117
R5:   118  /  0
R6:   118  /  0

Then, testing with both pos & neg DMM lead tips on each end of parts, then swapping neg for pos & vice versa,
D1:  122 / 79
D2:  122 / 79

> On Aug 8, 2016, at 1:43 PM, Don Wilhelm 
> S=1R0, V=8R9, L=0, C=0, N=t, B=0, F=1R07





--
View this message in context: http://elecraft.365791.n2.nabble.com/T1-as-stopped-tuning-correctly-tp7621358p7621374.html
Sent from the Elecraft mailing list archive at Nabble.com.