[Elecraft] KX3 to Computer

Don Wilhelm w3fpr at embarqmail.com
Thu Oct 29 17:55:39 EDT 2015


Forest,

That sounds like a problem between you and your computer.
If you are specific about the computer you are using, perhaps someone 
with the same setup can help you.  I think the solution (if any) will be 
found in the soundcard mixer.  It may or may not allow the selection of 
Line Out plus speaker.

73,
Don W3FPR

On 10/29/2015 5:40 PM, Forest Shick wrote:
> Thank you for all the information.
> I set the MIC BTN to OFF and adjusted the MIC GAIN for 4 bars (ALC) and turned on VOX.
>
> I am able to TX and RX SSTV, PSK32 and RTTY. (No contacts mostly receiving and transmitting into a dummy load until I have all the bugs worked out.)
>
> BUT I have to disconnect the LINE OUT from the computer to monitor the received signal and then plug it back in to transmit.
>
> Plugging in the LINE OUT connector to the computer mutes the computer speaker.
>
>



More information about the Elecraft mailing list