[Elecraft] KX3 to Computer

[Forest Shick]

Thank you for all the information. 
I set the MIC BTN to OFF and adjusted the MIC GAIN for 4 bars (ALC) and turned on VOX.

I am able to TX and RX SSTV, PSK32 and RTTY. (No contacts mostly receiving and transmitting into a dummy load until I have all the bugs worked out.)

BUT I have to disconnect the LINE OUT from the computer to monitor the received signal and then plug it back in to transmit.

Plugging in the LINE OUT connector to the computer mutes the computer speaker.

Any ideas on this issue.

Thank You,
Forest 
WA2MZG

-----Original Message-----
From: Martin Waller [mailto:martin at the-wallers.net] 
Sent: Wednesday, October 28, 2015 5:21 PM
To: Forest Shick <fshick at rochester.rr.com>; elecraft at mailman.qth.net
Subject: Re: [Elecraft] KX3 to Computer

Hi,
Good questions. I have been playing with RTTY myself this last few days and hit just that problem. I have been holding the microphone infront of the PC speaker in the interim as that worked as a temporary solution.
I would like to know the best way of doing this too.
MartinG0PJO 


     On Wednesday, 28 October 2015, 20:58, Forest Shick <fshick at rochester.rr.com> wrote:
   

 What is the easiest way to connect the KX3 to a computer for RTTY, PSK31 & SSTV. I have purchased the cable set. I connect the KX3 - Phones connector to the computer audio in and I can receive RTTY & SSTV. If I connect the computer audio out to the KX3 MIC, the radio goes into transmit. I would guess this is because the connector on the cable is incorrect for the MIC connector - too few contacts.

 

So how do you connect the audio for transmitting?

Thank You

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html Message delivered to martin at the-wallers.net