[Elecraft] KX3 to Computer

[Forest Shick]

That was too easy! I did as Bill suggested and used a Y connector. 

--...   ...--
Forest
WA2MZG

-----Original Message-----
From: Don Wilhelm [mailto:w3fpr at embarqmail.com] 
Sent: Thursday, October 29, 2015 5:56 PM
To: Forest Shick <fshick at rochester.rr.com>; 'Martin Waller'
<martin at the-wallers.net>; elecraft at mailman.qth.net
Subject: Re: [Elecraft] KX3 to Computer

Forest,

That sounds like a problem between you and your computer.
If you are specific about the computer you are using, perhaps someone with
the same setup can help you.  I think the solution (if any) will be found in
the soundcard mixer.  It may or may not allow the selection of Line Out plus
speaker.

73,
Don W3FPR

On 10/29/2015 5:40 PM, Forest Shick wrote:
> Thank you for all the information.
> I set the MIC BTN to OFF and adjusted the MIC GAIN for 4 bars (ALC) and
turned on VOX.
>
> I am able to TX and RX SSTV, PSK32 and RTTY. (No contacts mostly 
> receiving and transmitting into a dummy load until I have all the bugs 
> worked out.)
>
> BUT I have to disconnect the LINE OUT from the computer to monitor the
received signal and then plug it back in to transmit.
>
> Plugging in the LINE OUT connector to the computer mutes the computer
speaker.
>
>