[Elecraft] KSYN3A newest firmware : VCO:MD menu entry still there and delivers error

[Eric Swartz - WA6HHQ, Elecraft]

The new KSYN3a does not need the synth cal step. As noted in the manual, that only applies to the older synthesizer.

73,

Eric
elecraft.com
_..._



> On Mar 22, 2015, at 7:39 AM, Klaus Dittrich <kladit at arcor.de> wrote:
> 
> K3 SN 8887
> 
> MCU 5.14 / DSP 2.83 / FPF 1.19, 2/26/2015
> Latest Production Release
> 
> I still see CONFIG: VCO:MD -- and calibration started (digits count uwards) after leaving the menu but ends with an error after some time.
> 
> 
> I assume this can be ignored, as the KSYN3A does not need calibration?
> 
> Or is the KSYN3A not recognized by the firmware?
> 
> --
> 
> 73, Klaus, DF1TL
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to elist_copy at elecraft.com