[Elecraft] KSYN3A newest firmware : VCO:MD menu entry still there and delivers error

[Klaus Dittrich]

Am 03/22/15 um 16:40 schrieb Eric Swartz - WA6HHQ, Elecraft:
> The new KSYN3a does not need the synth cal step. As noted in the manual, that only applies to the older synthesizer.
>
> 73,
>
> Eric
> elecraft.com
> _..._
>
>
>
>> On Mar 22, 2015, at 7:39 AM, Klaus Dittrich <kladit at arcor.de> wrote:
>>
>> K3 SN 8887
>>
>> MCU 5.14 / DSP 2.83 / FPF 1.19, 2/26/2015
>> Latest Production Release
>>
>> I still see CONFIG: VCO:MD -- and calibration started (digits count uwards) after leaving the menu but ends with an error after some time.
>>
>>
>> I assume this can be ignored, as the KSYN3A does not need calibration?
>>
>> Or is the KSYN3A not recognized by the firmware?
>>
>> --
>>
>> 73, Klaus, DF1TL
>> ______________________________________________________________
>> Elecraft mailing list
>> Home: http://mailman.qth.net/mailman/listinfo/elecraft
>> Help: http://mailman.qth.net/mmfaq.htm
>> Post: mailto:Elecraft at mailman.qth.net
>>
>> This list hosted by: http://www.qsl.net
>> Please help support this email list: http://www.qsl.net/donate.html
>> Message delivered to elist_copy at elecraft.com

Eric, thank you.

I think I have read in the release notes that the item VCO:MD does not 
show up at all if the firmware has taken notice that a KSYN3a is installed.

Maybe something more for the todo list .. :-)

-- 
73, Klaus, DF1TL