[Elecraft] Newbie questions

[Mike Flowers]

Hi Urb,

Jay is quite correct.  The latest K3 Utility Program is here:
http://www.elecraft.com/K3/k3_software.htm

- 73 and good DX de Mike, K6MKF, President - NCDXC, IDXC 2015, W6NAG, IDXG,
ADXG, RRC #933, K3-P3-KPA500-KAT500 Addict, Maui


-----Original Message-----
From: Elecraft [mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Jay
K2TTT
Sent: Monday, September 15, 2014 10:06 AM
To: 'Urb LeJeune'; elecraft at mailman.qth.net
Subject: Re: [Elecraft] Newbie questions

Urb

It is easy:
1.You can reset everything by the following:

      Power off
      Hold in shift knob while pressing power on switch unit it fully powers
up

      You will have to start over again just like you had just finished
building it - so don't so this just for 	grins

      If you have an older configuration file saved you can reload it and be
right back where you were when you       	saved the file. The firmware
is not affected either way - kinda like a restore point in Win XP.

2.    The K3 utility program available "FREE" on their webste will do all
that.
      I would suggest that once you do a "reset" as above save it with the
utility program so you can always    	undo what you done did
 

73

K2TTT (Jay)C6ATT

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html Message
delivered to mike.flowers at gmail.com