[Elecraft] Newbie questions

[Eric Swartz - WA6HHQ, Elecraft]

Also, if your K3 was factory built and is not one of the earlier units shipped, 
we usually have the original factory config file recorded here. Contact 
support at elecraft.com and they can help you out.

Eric
elecraft.com

On 9/15/2014 10:18 AM, Mike Flowers wrote:
> Hi Urb,
>
> Jay is quite correct.  The latest K3 Utility Program is here:
> http://www.elecraft.com/K3/k3_software.htm
>
> - 73 and good DX de Mike, K6MKF, President - NCDXC, IDXC 2015, W6NAG, IDXG,
> ADXG, RRC #933, K3-P3-KPA500-KAT500 Addict, Maui
>
>
> -----Original Message-----
> From: Elecraft [mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Jay
> K2TTT
> Sent: Monday, September 15, 2014 10:06 AM
> To: 'Urb LeJeune'; elecraft at mailman.qth.net
> Subject: Re: [Elecraft] Newbie questions
>
> Urb
>
> It is easy:
> 1.You can reset everything by the following:
>
>        Power off
>        Hold in shift knob while pressing power on switch unit it fully powers
> up
>
>        You will have to start over again just like you had just finished
> building it - so don't so this just for grins
>
>        If you have an older configuration file saved you can reload it and be
> right back where you were when you       	saved the file. The firmware
> is not affected either way - kinda like a restore point in Win XP.
>
> 2.    The K3 utility program available "FREE" on their webste will do all
> that.
>        I would suggest that once you do a "reset" as above save it with the
> utility program so you can always    	undo what you done did
>