[Elecraft] Newbie questions

[Jay K2TTT]

Urb

It is easy:
1.You can reset everything by the following:

      Power off
      Hold in shift knob while pressing power on switch unit it fully powers
up

      You will have to start over again just like you had just finished
building it - so don't so this just for 	grins

      If you have an older configuration file saved you can reload it and be
right back where you were when you       	saved the file. The firmware
is not affected either way - kinda like a restore point in Win XP.

2.    The K3 utility program available "FREE" on their webste will do all
that.
      I would suggest that once you do a "reset" as above save it with the
utility program so you can always    	undo what you done did
 

73

K2TTT (Jay)C6ATT