[Elecraft] [K3] Using NaP3 in AFSK A mode

[Pete Smith N4ZR]

I just confirmed that offsets in the latest NaP3 setup menu have no 
effect when in AFSK A.  As someone reported, either here or elsewhere, 
this is apparently a bug in NaP3, and since NaP3 is no longer supported 
I'll have to find another solution.  Too bad - it was *so* close to perfect.

73, Pete N4ZR
Check out the Reverse Beacon Network at
http://reversebeacon.net,
blog at reversebeacon.blogspot.com.
For spots, please go to your favorite
ARC V6 or VE7CC DX cluster node.

On 10/2/2014 2:58 PM, Pete Smith N4ZR wrote:
> I would like to be able to use my K3 with NaP3 through an LP-PAN, but 
> when I click on a signal, instead of going where clicked it sends the 
> VFO to a frequency approximately 2 KHz lower.  I presume it may be 
> going to the suppressed carrier frequency instead of the Mark 
> frequency. Both NaP3 and the K3 are in AFSK A mode.
>