[Elecraft] [K3] Using NaP3 in AFSK A mode

[Barry LaZar]

Peter,
     I suggest that you probably don't want to go that route. What I 
would suggest is that you use some digital mode software behind the K3, 
something like FLDIGI, or your favorite application. You will see the 
stream of data on its waterfall and you would use that for final tuning. 
It also gives you the opportunity to use macros fairly easily. I do this 
with my KX3 with PSK31 from time to time and discovered this way through 
trial and error. It layers one additional on, but it appears to be a 
more convenient way to operate.

     If you are using HRD, you can use DM780 and have integral logging.

     However, with NaP3 there is a way to calibrate your operation. Go 
into configuration/rig and play with the IF offsets by mode. You should 
be able to fix your problem, but I really recommend my original 
suggestion. Best of Luck.

73,
Barry
K3NDM

On 10/2/2014 2:58 PM, Pete Smith N4ZR wrote:
> I would like to be able to use my K3 with NaP3 through an LP-PAN, but 
> when I click on a signal, instead of going where clicked it sends the 
> VFO to a frequency approximately 2 KHz lower.  I presume it may be 
> going to the suppressed carrier frequency instead of the Mark 
> frequency. Both NaP3 and the K3 are in AFSK A mode.
>