[Elecraft] K3 - second receiver for split ?

[Martin Kratoska]

I use a macro based on ZL2IFB's suggestions:

RT0;XT0;FR0;DV0;BW0040;SWT13;SWT13;UP4;SB1;BW0100;MN111;MP002;MN255;

It is assigned to PF1 (RIT button), you can do the job with K3 utils.

It copies the actual frequency to VFO B, moves the VFO 1 UP, sets on the 
corresponding filters. Now you listen the DX on your KRX3 while the main 
RX/TX is on the calling frequency. You can use QSK/QRQ while operating 
split.

I operate almost exclusively CW. For SSB you should modify the filter 
bandwidth and the UP shift (up 5 probably...).

73,
Martin, OK1RR

Dne 18.4.2014 16:46, Jim Miller napsal(a):
> I had just noticed those lines but didn't think they were necessarily the
> transmit freq as I was in CW and the line wasn't at 600 as I would have
> expected.  Figured it was new for something but did not further research
> them at the time.  I had my width wide to see the pileup and with it in the
> middle, no help.
>
> I am new at split.  Can I run split using my second receiver for the
> transmit freq??  Then narrow the receive width on the transmit frequency vfo
> so the line would be where it belongs???
>
> Thanks, 73, Jim KG0KP
>
> -----Original Message-----
> From: Jim Rogers [mailto:jim.w4atk at gmail.com]
> Sent: Friday, April 18, 2014 6:33 AM
> To: Jim Miller
> Subject: Re: [Elecraft] K3 - Transmit signal monitor display on my P3 - show
> location when split
>
> It does.  VFO A is the green line and VFO B is the cyan line, If you are on
> SSB it also shows the pass band  as either upper or lower sideband by which
> side of the marker it is on. CW will be centered in the pass band.
>
> 73s JIm, W4ATK
> On 4/18/2014 6:15 AM, Jim Miller wrote:
>> I want my signal to show me on my P3 where I am transmitting  split.
>> 73, Jim KG0KP
>>
>>
>> ______________________________________________________________
>> Elecraft mailing list
>> Home: http://mailman.qth.net/mailman/listinfo/elecraft
>> Help: http://mailman.qth.net/mmfaq.htm
>> Post: mailto:Elecraft at mailman.qth.net
>>
>> This list hosted by: http://www.qsl.net Please help support this email
>> list: http://www.qsl.net/donate.html Message delivered to
>> jim.w4atk at gmail.com
>>
>
>
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to martin at ok1rr.com
>