[Elecraft] K2 knob replacement

[Hisashi T Fujinaka]

Don, do you know about what the serial number was when the encoder
changed?

Thanks.

On Thu, 17 Apr 2014, Don Wilhelm wrote:

> For those owners of newer K2s, be aware that the NEW K2 encoder (those with a 
> board soldered to the back of the encoder) has a larger shaft diameter than 
> the older K2 encoders.
>
> I mention this as a way of warning newer K2 owners that the normal "K2" knob 
> may not fit your K2.
> The new encoder shaft diameter is the same as the K3 encoders, but the K3 VFO 
> A knob is too large for the K2 and the K3 VFO B knob may be too small in 
> diameter.
>
> Know what you have in your K2 before ordering a replacement knob.
>
> 73,
> Don W3FPR
>
> On 4/17/2014 4:53 PM, Dick, K2ZR wrote:
>> Review the link: http://www.73cnc.com/product_p/k2blkmain.htm
>> These folks make a great weighted knob for the K2. You can often pick it up
>> at hamfest where they are in the flea market. They generally offer a show
>> special for less. My guess is they will be at Dayton since trhey are 
>> located
>> in Ohio.
>> I've been a happy user.
>> 73,
>> Dick, K2ZR/4
>> 
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to htodd at twofifty.com
>

-- 
Hisashi T Fujinaka - htodd at twofifty.com
BSEE(6/86) + BSChem(3/95) + BAEnglish(8/95) + MSCS(8/03) + $2.50 = latte