[Elecraft] K2 knob replacement

[Don Wilhelm]

For those owners of newer K2s, be aware that the NEW K2 encoder (those 
with a board soldered to the back of the encoder) has a larger shaft 
diameter than the older K2 encoders.

I mention this as a way of warning newer K2 owners that the normal "K2" 
knob may not fit your K2.
The new encoder shaft diameter is the same as the K3 encoders, but the 
K3 VFO A knob is too large for the K2 and the K3 VFO B knob may be too 
small in diameter.

Know what you have in your K2 before ordering a replacement knob.

73,
Don W3FPR

On 4/17/2014 4:53 PM, Dick, K2ZR wrote:
> Review the link: http://www.73cnc.com/product_p/k2blkmain.htm
> These folks make a great weighted knob for the K2. You can often pick it up
> at hamfest where they are in the flea market. They generally offer a show
> special for less. My guess is they will be at Dayton since trhey are located
> in Ohio.
> I've been a happy user.
> 73,
> Dick, K2ZR/4
>