[Elecraft] setting upper cut/lower cut via commands

[Joe Subich, W4TV]

BW/BW$ and IS are more reliable since they are not impacted by the
K3 meta status.

73,

    ... Joe, W4TV


On 3/8/2013 8:15 AM, Don Wilhelm wrote:
> Brian,
>
> All I see is the FI and FW commands, so one must "do the math" to
> simulate HiCut or LoCut.  Move the IF center frequency by half the
> reduction in width.
>
> 73,
> Don W3FPR
>
> On 3/7/2013 9:27 PM, Brian Alsop wrote:
>> I don't seem to find any way to set upper cut and lower cut values via
>> a macro. The programmer's manual doesn't seem to have mnemonics to do
>> so Is it even possible?  I know one can set the bandwidth and shift.
>> Is that what we're supposed to do?  I'd rather set the individual
>> "cut" values independently.
>>
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>