[Elecraft] K3 TX DATA EQ <was> Re: K3 RX AUDIO

[iain macdonnell - N6ML]

If I try to adjust (with the VFO A knob) any of the sub-bands in
"MAIN:TX EQ x" (which are all "flat") whilst in DATA A or AFSK A mode,
the VFO B line displays "N/A". Curiously, though, when tapping the
number buttons, it does briefly display the SSB setting for that
sub-band, before the N/A "covers it up". I suppose that there's a some
logic in the firmware that overrides the stored values when in data
modes.

73,

    ~iain / N6ML


On Wed, Jul 24, 2013 at 11:34 AM, Joe Subich, W4TV <lists at subich.com> wrote:
>
> I'm telling you that the K3 sets TX EQ FLAT in DATA Modes.  I don't
> have my K3 with me but that's the documented behavior and matches
> what I've seen since the very beginning.
>
> If you see anything other that FLAT in TX EQ when your are DATA A or
> AFSK A, then your rig is not set up correctly.
>
> 73,
>
>    ... Joe, W4TV
>
>
>
> On 7/24/2013 2:21 PM, Sam Morgan wrote:
>>
>> Wed, 24 Jul 2013 11:04:08 -0700
>> Joe Subich, W4TV said:
>>
>>
>>  > TX EQ is automatically set to flat (as is RX EQ) in DATA modes.
>>  >
>> I knew that was suppose to be true for TX
>> But if you Tap [MENU] then RX EQ and then the numbers 1 - 8
>> you will see it say the settings match the ones you set for SSB.
>>
>> well then on the other hand ......
>> the TX EQ also says what SSB TX EQ is set to.
>>
>> So what you are telling me is to quit believing my lying eyes, hi hi.
>> The internal software is goofy and showing incorrect info to me?
>> Both TX & RX are set flat for *ALL* data modes, yes?
>>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html