[Elecraft] K3 TX DATA EQ <was> Re: K3 RX AUDIO

[Sam Morgan]

to clarify.....
I do/did understand the TX EQ is set to flat for transmit for *ALL* data modes!

what I was still curious about was
if the RX EQ is also flat (and *NOT* user configurable) on *ALL* data modes

I finally found my answer in the fine manual on page 52:
Revision D10, August 24, 2011

======
RX EQ
Receiver audio graphic equalizer. VFO A is used as an 8-band bar graph, showing
boost or cut ( -16 dB to +16 dB in 1 dB increments) for each AF band. The 8 bands
are 0.05, 0.1, 0.2, 0.4, 0.8, 1.6, 2.4 and 3.2 kHz. Tap 1 -8 to select an AF 
band. VFO
A selects boost/cut. Tap CLR to reset all bands to +0 dB.
CW RX EQ is separate from RX EQ for voice modes. Not applicable to DATA.
======

the last line answers my question. "Not applicable to DATA"

so when the mode is set to DATA TX
the RX EQ db level settings that I see in the display
*when* the 1-8 buttons are pushed, are incorrect .

in this case the flat line dashes
are the true representation of the RX EQ setting when in *ANY* Data mode

sorry for all the confusion folks.

topic closed please

-- 

GB & 73
K5OAI
Sam Morgan

On 7/24/2013 1:21 PM, Sam Morgan wrote:
> Wed, 24 Jul 2013 11:04:08 -0700
> Joe Subich, W4TV said:
>
>
>  > TX EQ is automatically set to flat (as is RX EQ) in DATA modes.
>  >
> I knew that was suppose to be true for TX
> But if you Tap [MENU] then RX EQ and then the numbers 1 - 8
> you will see it say the settings match the ones you set for SSB.
>
> well then on the other hand ......
> the TX EQ also says what SSB TX EQ is set to.
>
> So what you are telling me is to quit believing my lying eyes, hi hi.
> The internal software is goofy and showing incorrect info to me?
> Both TX & RX are set flat for *ALL* data modes, yes?
>