[Elecraft] ESSB Equalization
Richard Fjeld
rpfjeld at embarqmail.com
Sun Jan 27 23:47:42 EST 2013
I have watched ESSB signals on the P3 and I have this question; most receivers are limited to as narrow as 2.1 KHz, commonly 2.8 KHz on SSB. That is about all they are going to hear when listening to a wide ESSB signal. Unless someone with ESSB is in qso with a station of the same width, isn't it going to be wasted bandwidth?
Rich, n0ce
----- Original Message -----
From: Matt Zilmer
To: Mike Markowski
Cc: elecraft at mailman.qth.net
Sent: Saturday, January 26, 2013 8:08 PM
Subject: Re: [Elecraft] ESSB Equalization
It works quite well too! Looks like Wide SSB TX and plain SSB TX are
always left with the same profile.
73,
matt W6NIA
On Sat, 26 Jan 2013 18:54:17 -0500, you wrote:
>I wrote a tiny program for adjusting the 3 EQ settings:
>
> http://udel.edu/~mm/ham/elecraft/
>
>and click on the Elecraft logo for the K3 EQ program.
>
>This doesn't compare to elaborate programs that do much more, but might
>be useful for a simple EQ adjustment. Not tested on all OSes, so no
>guarantees. :-)
>
>73,
>Mike ab3ap
>
>On 01/26/2013 06:48 PM, Matt Zilmer wrote:
>> Hi Ron,
>>
>> Go the CONFIG:TX ESSB menu. Push the '1' key until VFO A reads, On or
>> OFF. If it's OFF, push the '1' key again and you should see it read
>> 'On'.
>>
>> Use VFO A to set the width you want. Then exit the menu.
>>
>> 73,
>> matt W6NIA
>______________________________________________________________
>Elecraft mailing list
>Home: http://mailman.qth.net/mailman/listinfo/elecraft
>Help: http://mailman.qth.net/mmfaq.htm
>Post: mailto:Elecraft at mailman.qth.net
>
>This list hosted by: http://www.qsl.net
>Please help support this email list: http://www.qsl.net/donate.html
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
More information about the Elecraft
mailing list