[Elecraft] ESSB Equalization

[Matt Zilmer]

It works quite well too!  Looks like Wide SSB TX and plain SSB TX are
always left with the same profile.

73,
matt W6NIA

On Sat, 26 Jan 2013 18:54:17 -0500, you wrote:

>I wrote a tiny program for adjusting the 3 EQ settings:
>
>   http://udel.edu/~mm/ham/elecraft/
>
>and click on the Elecraft logo for the K3 EQ program.
>
>This doesn't compare to elaborate programs that do much more, but might 
>be useful for a simple EQ adjustment.  Not tested on all OSes, so no 
>guarantees.  :-)
>
>73,
>Mike ab3ap
>
>On 01/26/2013 06:48 PM, Matt Zilmer wrote:
>> Hi Ron,
>>
>> Go the CONFIG:TX ESSB menu.  Push the '1' key until VFO A reads, On or
>> OFF.  If it's OFF, push the '1' key again and you should see it read
>> 'On'.
>>
>> Use VFO A to set the width you want.  Then exit the menu.
>>
>> 73,
>> matt W6NIA
>______________________________________________________________
>Elecraft mailing list
>Home: http://mailman.qth.net/mailman/listinfo/elecraft
>Help: http://mailman.qth.net/mmfaq.htm
>Post: mailto:Elecraft at mailman.qth.net
>
>This list hosted by: http://www.qsl.net
>Please help support this email list: http://www.qsl.net/donate.html