[Elecraft] P3/SVGA Beta Firmware 1.24/1.14 Now Available

[Stephen Prior]

I have a very similar problem.  Some files get transferred and the P3
reports that it is on 1.24 but other FPGA files fail with the utility
claiming that it is not responding.

Stephen G4SJP



On 19 January 2013 06:32, Charlie Delta <vk3od at yahoo.com> wrote:

> Hi Paul
>
> I have had all sorts of problems trying to update to this beta release.
>
> The upload crashed after the MCU load. I tried several times with no
> success.
> It seems that something gets corrupted after the reset process.
> The P3 does actually reset however the update to the P3 Utility seems
> rather slow.
>
> I even tried using the MCU bootloader with the same failure.  I have tried
>  about 6
> times and it has failed on every attempt. I thought that  it was the
> USB-serial driver that got corrupted. I tried a dedicated RS232 port on
> another PC with the same result.
> I also disconnected the K3 from the P3 with no success.
>
> I have successfully loaded the previous beta so I presume that their is no
> issue
> with my PC setup. This might be some issue with my P3, although its running
> fine after re- installing the previous beta.
>
>  Is there something different in this beta release that makes loading
> problematic?
>
> Craig
> VK3OD
>
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>