[Elecraft] P3/SVGA Beta Firmware 1.24/1.14 Now Available

[Tom H Childers]

It worked fine for me.

The first thing I noticed was what seemed to be faster response time
for the noise and signal peaks, which is an improvement.

On Fri, 18 Jan 2013 22:32:17 -0800 (PST), Charlie Delta
<vk3od at yahoo.com> wrote:

>Hi Paul
>
>I have had all sorts of problems trying to update to this beta release. 
>
>The upload crashed after the MCU load. I tried several times with no success.
>It seems that something gets corrupted after the reset process.
>The P3 does actually reset however the update to the P3 Utility seems rather slow.
>
>I even tried using the MCU bootloader with the same failure.  I have tried  about 6
>times and it has failed on every attempt. I thought that  it was the USB-serial driver that got corrupted. I tried a dedicated RS232 port on another PC with the same result.
>I also disconnected the K3 from the P3 with no success.
>
>I have successfully loaded the previous beta so I presume that their is no issue
>with my PC setup. This might be some issue with my P3, although its running
>fine after re- installing the previous beta.
>
> Is there something different in this beta release that makes loading problematic?
>
>Craig
>VK3OD
>
>
>______________________________________________________________
>Elecraft mailing list
>Home: http://mailman.qth.net/mailman/listinfo/elecraft
>Help: http://mailman.qth.net/mmfaq.htm
>Post: mailto:Elecraft at mailman.qth.net
>
>This list hosted by: http://www.qsl.net
>Please help support this email list: http://www.qsl.net/donate.html
73,
Tom
Amateur Radio Operator N5GE
ARRL Lifetime Member
QCWA Lifetime Member