[Elecraft] Macros

[Don Wilhelm]

Jim,

Why are you re-doing the macro in a continuous loop?
More specific, why do you have the SWH45 and SWH47 included in the macro.
If you assign the first macro to PF1, and then initiate it with a hold 
of PF1. it will execute the MD3, then BW0040, but when it sees the 
SWH45, it will start all over again, and will never end.

I am not certain how it could be working right now.

73,
Don W3FPR

On 2/16/2013 2:12 PM, Jim Leder (Hotmail) wrote:
> The 2 macros I use work OK since I reloaded the firmware. I tried so 
> many different, fancy things prior to getting messed up, I'm not sure 
> what they were now, but it was a lot. That's when I attempted to go 
> back to what I knew was OK, but they didn't work either. That's when I 
> got desperate and as a last resort, reloaded the 4.60 firmware.
>
> Here are the two ORIGINAL macros that now work once again:
>
> CW MD3;BW0040;SWH45;MN255;   /* PF1 hold */
> FSK MD6;DT2;BW0050;SWH47;MN255;  /* PF2  hold */
>
> Seems something in the firmware got out of sorts by my screwing around 
> with those two macros, but I don't know how.
>