[Elecraft] (no subject)

[Jim Rhodes]

I have been thinking of using this logic to switch the PTT output with a
relay to the  proper amp. Has anyone done this to give me a headstart on
the project?

Jim K0XU Sent from my Xoom tablet
On Feb 16, 2013 2:46 AM, "Oliver Dröse" <droese at necg.de> wrote:

> But not as a PTT signal (that was the question). DIGOUT1 is either
> permanently on or off, depending on band-specific menu setting. To use it
> as a band-specific PTT output is not possible.
>
> 73, Olli - DH8BQA
>
>
>
>
> Am 16.02.2013 um 09:30 schrieb Edward R Cole <kl7uw at acsalaska.net>:
>
> > Richard,
> >
> > Yes, DIGOUT-1 can be used on any band by enabling it in CONFIG: to "ON".
> >
> > 73, Ed - KL7UW
> > ---------------------------------------------------------
> > Date: Thu, 14 Feb 2013 18:00:26 -0800
> > From: Richard Thorpe <kissov at me.com>
> > To: elecraft at mailman.qth.net
> > Subject: [Elecraft] DIGOUT1
> > Message-ID: <C76BE011-3B1A-4871-8397-EADEEC74FD53 at me.com>
> > Content-Type: text/plain; charset=us-ascii
> >
> > Can I use DIGOUT1 ( pin 11 ACC connector) to key an external 2 meter amp
> ( ground on transmit) connected to ANT 3.  When I PTT I want to key the 2
> meter amp without keying the 160-10 amp connected to ANT1.  Thank you
> >
> > K6CG
> >
> > ______________________________________________________________
> > Elecraft mailing list
> > Home: http://mailman.qth.net/mailman/listinfo/elecraft
> > Help: http://mailman.qth.net/mmfaq.htm
> > Post: mailto:Elecraft at mailman.qth.net
> >
> > This list hosted by: http://www.qsl.net
> > Please help support this email list: http://www.qsl.net/donate.html
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>