[Elecraft] Norm1 and Norm2 how to switch between them???

[David Ferrington, M0XDF]

Push, and hold for at least 2 seconds (until VFOB indicates '<-- SAV -->') the SHIFT/LO/NORM knob and then twist anti-clockwise for NORM1 and clockwise for NORM2.

To recall then just push and twist.
73 de David, M0XDF (K3 #174, P3 #108)
-- 
Anyone can do any amount of work, provided it isn't the work he is supposed
to be doing at that moment. -Robert Benchley

On 11 Feb 2013, at 16:35, Ron Midwin wrote:

> so here I was, playing on my K3, S/N 1997 yesterday, enjoying both my nex
> Hexbeam (K4KIO) and new call, KB6G (formerly AE6RH).
> 
> things were getting too quiet, so I decided to see what kind of mischief I
> could get into, and this usually involved re-reading the multitude of K3
> manuals; including the Nifty Manual that I find very useful for quickly
> getting to a topic.
> 
> when I first set up my K3 several years ago, I played with most of the
> settings, but never really paid much attention to the Norm1 and Norm2
> controls.  I noticed in the manual(s) that if I set the Norm1 for my 2.7
> KHz filter the K3 came with, and set Norm2 for the 2.1 KHz SSB filter I
> added, then it looked like I could quickly switch between them and go back
> and forth to compare them.
> 
> so I read the "instructions" on how to save these settings, and as much as
> I tried everything, I could not save them both so that I can swap settings.
> 
> so my question to the group is; has anyone else run into this and can
> someone who has broken the code clue me in?
> 
> Just in case you need to know, I have a single receiver K3 with 400 Hz and
> 6.0 KHz filters also.