[Elecraft] K2/100 - "Info 080" message

[Don Wilhelm]

Tom,

An INFO 080 message is the result of a failure of the MCU to obtain the 
expected response from another microprocessor in the expected time.

Since it does not happen when you disconnect the KAT100, I would suggest 
first checking the connecting cable, then the AUXBUS path in the 
KAT100.  Try reseating the KAT100 firmware IC if you do not find a cable 
problem, and if all else fails, replace the KAT100 firmware.

73,
Don W3FPR

On 2/6/2013 8:46 AM, Tom Warren wrote:
>     On the heels of my XV432 'issue', and totally unrelated because the XV432 is
> interfaced to a FlexRadio, my faithful K2/100 is showing an "Info 080" message on startup.
> I've found that by unplugging the DB9 from my KAT100 the rig operates normally.
>
>    What is my next step to track down the problem ?
>
>
>     All suggestions welcome ;0)
>
>    73
> Tom
> W4TMW
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>