[Elecraft] KX3 assembly manual question

[Don Wilhelm]

Bruce,

The instructions have changed.  Did you receive a KXFL3 option quite 
recently?  If so, there should have been a small 2 turn loop antenna 
supplied with it - along with the instructions.

I do have a preliminary copy of the instructions - because I field 
tested those instructions.
If you have a real need to obtain them, send me an off-list email - 
actually I was hoping someone at Elecraft would answer you and could 
likely give you more updated info, but I think the key players in this 
are getting ready to go to Dayton and don't have time to read the reflector.

73,
Don W3FPR

On 5/16/2012 4:04 PM, Bruce Beford wrote:
> At the end of the KX3 assembly manual, the following statement is seen:
>
>   2) If you installed the KXFL3, calibrate it as shown on the instruction
> sheet supplied with the KXFL3 module.
>
> I note that the instruction sheet for the KXFL3 module is not yet available
> on the Elecraft manuals download page. Could it be posted please, for
> download and review of these calibration instructions?
>
>