[Elecraft] KX3 assembly manual question

[Bruce Beford]

Thanks, JP. That reads as if the relevant procedure is duplicated in the
Owner's Manual proper. Shame on me for not checking there in the first
place. I'll go over that section in the owner's manual (still waiting on my
kit, so I've got some time...)

73,

Bruce, N1RX

 

  _____  

From: JP O'Connor [mailto:jpoc.yoda at gmail.com] 
Sent: Wednesday, May 16, 2012 5:19 PM
To: Bruce Beford
Cc: elecraft at mailman.qth.net
Subject: Re: [Elecraft] KX3 assembly manual question

 

Absent the referenced document, possibly the information you seek is in the
KX3 Owner's Manual. Specifically on page 31: "If you install a KXFL3 roofing
filter during KX3 kit assembly, or install one in a factory assembled KX3
after initial purchase, you'll need to perform the Receive Sideband
calibration step (pg 32)."

 

If these are both the same thing, then possibly the assembly manual could
also be adjusted: "2) If you installed the KXFL3, calibrate it as shown on
the instruction sheet supplied with the KXFL3 module or as shown in the
Calibration section of the KX3 Owner's Manual."

 

Hope this helps!

 

73 de JP WF4Z



 

On Wed, May 16, 2012 at 4:04 PM, Bruce Beford <bruce.beford at myfairpoint.net>
wrote:

At the end of the KX3 assembly manual, the following statement is seen:

 2) If you installed the KXFL3, calibrate it as shown on the instruction
sheet supplied with the KXFL3 module.

I note that the instruction sheet for the KXFL3 module is not yet available
on the Elecraft manuals download page. Could it be posted please, for
download and review of these calibration instructions?

Thanks,
Bruce, N1RX


______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html