[Elecraft] KX3 assembly manual question

[JP O'Connor]

Absent the referenced document, possibly the information you seek is in the
KX3 Owner's Manual. Specifically on page 31: "If you install a KXFL3
roofing filter during KX3 kit assembly, or install one in a factory
assembled KX3 after initial purchase, you’ll need to perform the Receive
Sideband calibration step (pg 32)."

If these are both the same thing, then possibly the assembly manual could
also be adjusted: "2) If you installed the KXFL3, calibrate it as shown on
the instruction sheet supplied with the KXFL3 module or as shown in the
Calibration section of the KX3 Owner's Manual."

Hope this helps!

73 de JP WF4Z



On Wed, May 16, 2012 at 4:04 PM, Bruce Beford
<bruce.beford at myfairpoint.net>wrote:

> At the end of the KX3 assembly manual, the following statement is seen:
>
>  2) If you installed the KXFL3, calibrate it as shown on the instruction
> sheet supplied with the KXFL3 module.
>
> I note that the instruction sheet for the KXFL3 module is not yet available
> on the Elecraft manuals download page. Could it be posted please, for
> download and review of these calibration instructions?
>
> Thanks,
> Bruce, N1RX
>
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>