[Elecraft] KX3 assembly manual question

[Bruce Beford]

No problem, Don. I reviewed the Opposite Sideband null instructions in the
latest KX3 Owner's manual (Rev B1, dated 4/24/12). The instructions appear
clear and complete. They do mention using the antenna wire to pick up the
MCU's 16MHz oscillator, if that is used as the source. I should be all set.
Thanks es 73,
Bruce

-----Original Message-----
From: Don Wilhelm [mailto:w3fpr at embarqmail.com] 
Sent: Wednesday, May 16, 2012 5:42 PM
To: Bruce Beford
Cc: elecraft at mailman.qth.net
Subject: Re: [Elecraft] KX3 assembly manual question

Bruce,

The instructions have changed.  Did you receive a KXFL3 option quite 
recently?  If so, there should have been a small 2 turn loop antenna 
supplied with it - along with the instructions.

I do have a preliminary copy of the instructions - because I field 
tested those instructions.
If you have a real need to obtain them, send me an off-list email - 
actually I was hoping someone at Elecraft would answer you and could 
likely give you more updated info, but I think the key players in this 
are getting ready to go to Dayton and don't have time to read the reflector.

73,
Don W3FPR

On 5/16/2012 4:04 PM, Bruce Beford wrote:
> At the end of the KX3 assembly manual, the following statement is seen:
>
>   2) If you installed the KXFL3, calibrate it as shown on the instruction
> sheet supplied with the KXFL3 module.
>
> I note that the instruction sheet for the KXFL3 module is not yet
available
> on the Elecraft manuals download page. Could it be posted please, for
> download and review of these calibration instructions?
>
>