[Elecraft] K3 4.51 is now production released

[Dick Dievendorff]

This sounds like you may have failed to load the appropriate front panel
flash (FPF) firmware.  I'd try reloading all firmware.

Dick, K6KR


-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Michael Downs
Sent: Friday, July 06, 2012 7:14 PM
To: eric at elecraft.com
Cc: Elecraft Reflector
Subject: Re: [Elecraft] K3 4.51 is now production released

I just loaded firmware 4.51 on my K3. Everything went smoothly. The load of
MCU and DSP 1 and 2 were verified by the K3 Utility. However, now my front
panel buttons no longer work properly. For example, PRE turns on/off NTCH.
All the buttons seem to be affected. However, if I use the K3 Utility to
send commands to the K3 they seem to work properly.

I tried loading all the software again, including the front panel firmware.
Again the K3 Utility verifies the install, but the front panel buttons are
messed up. Help!!!

Mike, ks7d

On Jul 5, 2012, at 7:22 PM, Eric Swartz - WA6HHQ, Elecraft wrote:

> We've moved K3 f/w 4.51 and its matching DSP code from beta to final 
> release mode. K3 utility should now automatically see it when you 
> check for new f/w.
> 
> 73,
> 
> --
> Eric  WA6HHQ
> ---
> www.elecraft.com
> 
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net Please help support this email 
> list: http://www.qsl.net/donate.html

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html