[Elecraft] K3 4.51 is now production released

[Don Wilhelm]

Mike,

This is not a 4.51 problem as far as I know - many have loaded it 
without incident.

Hopefully you have a saved K3 configuration file.  I would think you 
will have to do an EE INIT (Parameter Initialization) to recover, then 
re-load the firmware and finally restore the configuration data.

If you do not have the saved configuration file, wait until Monday and 
contact K3support so they can lead you through the process of 
initializing all your options and doing the calibration steps - figure a 
1 to 2 hour task for that.

73,
Don W3FPR

On 7/6/2012 10:13 PM, Michael Downs wrote:
> I just loaded firmware 4.51 on my K3. Everything went smoothly. The load of MCU and DSP 1 and 2 were verified by the K3 Utility. However, now my front panel buttons no longer work properly. For example, PRE turns on/off NTCH. All the buttons seem to be affected. However, if I use the K3 Utility to send commands to the K3 they seem to work properly.
>
> I tried loading all the software again, including the front panel firmware. Again the K3 Utility verifies the install, but the front panel buttons are messed up. Help!!!
>
> Mike, ks7d
>
>