[Elecraft] K3 4.51 is now production released

[Michael Downs]

I just loaded firmware 4.51 on my K3. Everything went smoothly. The load of MCU and DSP 1 and 2 were verified by the K3 Utility. However, now my front panel buttons no longer work properly. For example, PRE turns on/off NTCH. All the buttons seem to be affected. However, if I use the K3 Utility to send commands to the K3 they seem to work properly.

I tried loading all the software again, including the front panel firmware. Again the K3 Utility verifies the install, but the front panel buttons are messed up. Help!!!

Mike, ks7d

On Jul 5, 2012, at 7:22 PM, Eric Swartz - WA6HHQ, Elecraft wrote:

> We've moved K3 f/w 4.51 and its matching DSP code from beta to final 
> release mode. K3 utility should now automatically see it when you check 
> for new f/w.
> 
> 73,
> 
> -- 
> Eric  WA6HHQ
> ---
> www.elecraft.com
> 
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html