[Elecraft] Question

[Don Wilhelm]

Milt,

The most direct way is to remove the right side panel.
You will find instructions to do that on page 26 of the KRX3 
installation manual.  You will probably have to remove the KRX3 assembly 
to gain access to the nuts holding the two regulators to the side panel.

73,
Don W3FPR

On 12/31/2012 5:16 PM, Milt -- N5IA wrote:
> Don and the list,
>
> This is my first time to need any guidance.  I appreciate in advance 
> the reply to my question.
>
> The BNC connector for the AUX RF input has become loose on my K3.
>
> I cannot determine the best manner of accessing the inside of the rear 
> panel so I can tighten the nut on the rear of the connector body.
>
> It has been 4+ years since I have had this radio open and do not 
> remember (nor can I find in the construction manual) the most 
> efficient, least obtrusive method of gaining access to the rear of the 
> connector.
>
> All suggestions are appreciated.
>
> Thanks, and Happy New Year to everyone.
>
> de Milt, N5IA
>
>
> -----
> No virus found in this message.
> Checked by AVG - www.avg.com
> Version: 2013.0.2805 / Virus Database: 2637/5975 - Release Date: 12/20/12
> Internal Virus Database is out of date.
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>