[Elecraft] K3: "SPKR+PH" - not sticky

[Jack Berry]

Gotta like low tech! Works without software and shielded cables. 

On Dec 18, 2012, at 7:13 PM, "PTA_ABD" <wb2abd at roadrunner.com> wrote:

> Almost the same problem here. The difference is that toggling SPKR+PH on and off has no effect. I'm also sure the MCU isn't the reason, as this popped up well after changing to 4.6, but I suppose there could be different reasons for you and I.  I have convinced myself that the headphone jack up front is the problem. As usual, dissassembling stuff is a problem with bad fingers. The present quick fix is to put a small book over the speaker ... klutzy but works quite well.
> 
> Paul WB2ABD
> 
> 
> <
> I use headphones on SSB most of the time through the front PHONES jack. I
> have the "SPKR+PH" option set to 'no'. MCU 4.6 installed.
> Not 
> always, but too often when I have been listening through the speaker and
> decide to plug in the headphones I get audio in both headphones and 
> speaker.
> If I go back to CONFIG: SPKR+PH and toggle between 'yes' and
> 'no', the problem is cured for that session. I have no identified any 
> other actions that precede the event but I'm certain it shouldn't be 
> happening.
> 
> Any others with this experience or a fix for the problem?
> 
> 
> ?
> God Bless?&?73!
> Jack - WE5ST
> 
> 
> 
> __________ Information from ESET Smart Security, version of virus signature database 7814 (20121218) __________
> 
> The message was checked by ESET Smart Security.
> 
> http://www.eset.com
> 
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html