[Elecraft] K3: "SPKR+PH" - not sticky

[PTA_ABD]

Almost the same problem here. The difference is that toggling SPKR+PH on and off has no effect. I'm also sure the MCU isn't the reason, as this popped up well after changing to 4.6, but I suppose there could be different reasons for you and I.  I have convinced myself that the headphone jack up front is the problem. As usual, dissassembling stuff is a problem with bad fingers. The present quick fix is to put a small book over the speaker ... klutzy but works quite well.

Paul WB2ABD


<
 I use headphones on SSB most of the time through the front PHONES jack. I
 have the "SPKR+PH" option set to 'no'. MCU 4.6 installed.
Not 
always, but too often when I have been listening through the speaker and
 decide to plug in the headphones I get audio in both headphones and 
speaker.
If I go back to CONFIG: SPKR+PH and toggle between 'yes' and
 'no', the problem is cured for that session. I have no identified any 
other actions that precede the event but I'm certain it shouldn't be 
happening.

Any others with this experience or a fix for the problem?


?
God Bless?&?73!
Jack - WE5ST
>



__________ Information from ESET Smart Security, version of virus signature database 7814 (20121218) __________

The message was checked by ESET Smart Security.

http://www.eset.com