[Elecraft] K3 Split-Mode CW pressing "Rev" Problem

[Don Wilhelm]

Bob,

Look at the "Split Mode with the Sub receiver:" portion of the manual

As typical in split mode, you will transmit on VFO B and receive on VFO A.

Do not fall into the trap of mentally associating VFO A with the main 
and VFO B with the sub.  It is sometimes that way, but not always - 
consider that there is no transmit associated with the subRX, but there 
certainly is transmit associated with VFO B when in split.

If using the SubRX in diversity mode, split works the same as a K3 
without the sub, but if you are in non-diversity, there is no need for 
split - VFO A will be your TX frequency and VFO B will move the subRX to 
whatever frequency you want to listen to (the DX station).

73,
Don W3FPR

On 12/6/2012 9:16 AM, KD7YZ Bob wrote:
> On Thursday Wilhelm used a Straight-Key to send:
> -------------Original Comment-------
>> Bob,
>> That is the way it is supposed to work if you do not have a SubRX in
>> your K3.
> Ah, but I do have a Sub-Rx and likely no clue how to make use of it yet.
> Also, I was not using the Cans but rather just the Bose Speakers. I'll
> have to try the Heil cans .. might be a nifty way to hear the other
> freq.
>
>
>
> So, what then is the correct way to work CW split since I have a matched
> Sub-Rx in the K3?
>
>