[Elecraft] Spot button QSYs K3

[Greg]

What firmware version is being used?  When using the auto tune function the
radio should go into fine tune mode and then turn it off after the tuning is
done.

73
Greg



On Wed, Oct 19, 2011 at 3:52 PM, Dennis Moore <dennis at mail4life.net> wrote:

> Others have mentioned the Autospot feature, and here's an observation on
> that as it relates to your issue of a large freq change.
>
> If my freq resolution is at 10Hz or 100Hz and I try to Autospot, I will
> get a 2kHz shift as you described. If, however, I am set to 1Hz
> resolution, the Autospot feature brings the frequency right where it is
> supposed to be.
>
> 73, Dennis NJ6G
>
> On 10/19/2011 5:30 AM, Robby.VY2SS wrote:
> > Using F/W upgrade 4.39.
> >
> > I just noticed that when I push the spot button the K3 will QSY down a
> > little over 2 khz. It is never the exact same amount. It does not
> > necessarily stop on a signal. This happens when I have a CW signal in the
> > passband or not. The last three times I did the calculation it went
> -2.176
> > khz, -2.146 khz and -2.189 khz. Is this a result of my recent upgrade or
> > finger trouble. (again)
> >
> > -Robby
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>