[Elecraft] Spot button QSYs K3

[Dennis Moore]

Others have mentioned the Autospot feature, and here's an observation on 
that as it relates to your issue of a large freq change.

If my freq resolution is at 10Hz or 100Hz and I try to Autospot, I will 
get a 2kHz shift as you described. If, however, I am set to 1Hz 
resolution, the Autospot feature brings the frequency right where it is 
supposed to be.

73, Dennis NJ6G

On 10/19/2011 5:30 AM, Robby.VY2SS wrote:
> Using F/W upgrade 4.39.
>
> I just noticed that when I push the spot button the K3 will QSY down a
> little over 2 khz. It is never the exact same amount. It does not
> necessarily stop on a signal. This happens when I have a CW signal in the
> passband or not. The last three times I did the calculation it went -2.176
> khz, -2.146 khz and -2.189 khz. Is this a result of my recent upgrade or
> finger trouble. (again)
>
> -Robby