[Elecraft] Weak Signal Propagation Reporter WSPR software (need help with it)

[John Ragle]

These are the settings I have used...

To run WSJT on K3 with SignaLinkUSB:

(The soundcard settings that FLDIGI takes care of automatically, when 
set up, must be done MANUALLY in WSJT. Otherwise, the setup is the same.)
1.K3 in “TX DATA”
2.K3 at 50.260 (for six meter operation)
3.K3 with “CONFIG” “LINE OUT” ~ 20. This depends on Digital Gain Setting 
on SpecJT (lower right-hand side).
4.SignaLink-USB ON
5.PC “Playback Devices” (right-click on speaker mini-icon) must have 
“Speakers USB Audio Codec” as “Default Device”
6.PC “Recording Devices” must have “Microphone USB Audio Codec” as 
“Default Device”
(Items 5 and 6 are the soundcard settings, obviously)

John Ragle -- W1ZI

=====

On 5/29/2011 8:17 PM, goldtr8 at charter.net wrote:
> Would someone who is using the WSPR software share how they have the
> setup configured for the K3.
>
> I can not get it to go to TX.  I have something wrong with either the
> CAT or PTT settings.