[Elecraft] Ref Osc calibration question

[Amateur Radio Operator N5GE]

When you put the rig in AM Sync the rig will follow any changes in the received
signal to "Sync" with it.  You will also notice that you are actually on SSB in
this mode.

What you saw was normal.  I hope you remember what the original setting of the
Ref Osc was.

The manual has a good description of how AM Sync works.

73,

Tom Childers
Radio Amateur N5GE
Licensed since 1976
QCWA Life Member 35102
ARRL Life Member
Retired Professional
C# Software developer
http://www.n5ge.net

On Sun, 30 Jan 2011 14:12:42 -0800 (PST), w0ih <mfroster at msn.com>  wrote:

>
>I noticed that when I went to AM-S (AM Sync, AutoTracking), that the
>frequency showed:
>  10.000.010
>
>So, I figure that the Reference Oscillator was off a bit.  So I tweeked the
>oscillator slightly until the frequency showed 10.000.000 when I when out of
>the Config Menu.
>
>Is there anything wrong with this logic?  
>
>  I couldn't seem to hear beat oscillator when I get close to the 10 Mhz
>signal to adjust it by the manual.
>
>Mike