[Elecraft] K2 warping

[John Ragle]

Both my K2 (long gone) and my K3 had this issue. I finally just wrapped 
about 2 turns of vinyl tape around the little rubber bumper on the right 
side of the tilt-up bail, experimenting with the amount until everyone 
was happy. My K3 was a factory-assembled unit, and the wobble was NOT 
because the desktop was bowed. Like Dan, I am using a hard, planar table 
top. No biggie...

John Ragle -- W1ZI

=====

On 1/12/2011 8:49 PM, Dan Grizzard wrote:
> My K2 has developed a warping issue. Recently completed and finally totally assembled the unit does not set flat on the desk or stand. It wobbles. I have loosened the 3d connector screws, set heavy books on the rig on a marble top table and then re-tightened the screws. The rig then sits flat with no wobble. The next morning the warp is back. Has anyone had this issue?